(a) Disconnect the air fuel ratio sensor connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
Standard Resistance (Check for Short):
Text in Illustration
(d) Reconnect the air fuel ratio sensor connector.
(e) Reconnect the ECM connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (AIR FUEL RATIO SENSOR - ECM)
OK -- Continue to next step.
2. REPLACE AIR FUEL RATIO SENSOR
(a) Replace the air fuel ratio sensor See: Powertrain Management/Computers and Control Systems/Oxygen Sensor/Service and
Repair/Air Fuel Ratio Sensor/Removal.
NEXT -- Continue to next step.
3. CHECK WHETHER DTC OUTPUT RECURS
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
No comments:
Post a Comment