WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK PRESENT DTC
(a) Turn the engine switch on (IG), and wait for at least 60 seconds.
(b) Check for present DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/DTC Check / Clear.
Result:
HINT
* DTCs indicating communication errors will be changed to DTCs indicating errors in initialization by turning the engine switch
off and then to on (IG) again.
* Codes other than DTC B1627, B1628, B1637, B1638, B1647, B1648, and 82 may be output at this time, but they are not related
to this check.
E -- USE SIMULATION METHOD TO CHECK See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
D -- CHECK SIDE AIRBAG SENSOR LH
C -- CHECK CONNECTORS
B -- CHECK CONNECTORS
A -- Continue to next step.
2. CHECK PAST DTC
(a) Turn the engine switch on (IG), and wait for at least 60 seconds.
(b) Check for past DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
No comments:
Post a Comment