Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. REPLACE TELEVISION DISPLAY ASSEMBLY LH
(a) Replace the television display assembly LH See: Accessories and Optional Equipment/Entertainment Systems/Television /
Monitor/Service and Repair/Removal.
(b) Clear the DTCs See: Accessories and Optional Equipment/Entertainment Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes.
(c) Recheck for DTCs and check if the same trouble occurs again.
OK:
No DTCs are output.
NG -- REPLACE MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY See: Accessories and Optional
Equipment/Entertainment Systems/Entertainment System Control Module/Service and Repair/Rear Seat Entertainment ECU/Removal
OK -- END (TELEVISION DISPLAY ASSEMBLY LH WAS DEFECTIVE)
1. CHECK HARNESS AND CONNECTOR (MULTI-DISPLAY CONTROLLER - TELEVISION DISPLAY ASSEMBLY LH)
(a) Disconnect the multi-display controller sub-assembly connector.
(b) Disconnect the television display assembly LH connector.
(c) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment