NG -- REPLACE TRANSMISSION WIRE See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Wiring
Harness/Service and Repair/U660E Automatic Transaxle/Removal
OK -- Continue to next step.
3. REPLACE SPEED SENSOR
(a) See: Powertrain Management/Transmission Control Systems/Sensors and Switches - Transmission and Drivetrain/Sensors and
Switches - A/T/Transmission Speed Sensor/Service and Repair/U660E Automatic Transaxle/Removal.
NEXT -- Continue to next step.
4. CHECK IF DTC OUTPUT RECURS (SEE IF DTC P0715 AND/OR P0717 OUTPUT AGAIN)
(a) Connect the Techstream to the DLC3.
(b) Start the engine and turn the Techstream on.
(c) Enter the following menus: Powertrain / ECT / DTC / Clear.
HINT
Write down the currently output DTCs before clearing them.
(d) Perform the monitor drive pattern See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/U660E Automatic Transaxle System.
(e) Enter the following menus: Powertrain / ECT / DTC.
(f) Read the DTCs using the Techstream.
Result:
B -- END
A -- REPLACE TCM See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and
Drivetrain/Relays and Modules - A/T/Control Module/Service and Repair/U660E Automatic Transaxle/Removal
Up to 08/2009
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSAXLE SYSTEM: P0715,P0717: Input / Turbine Speed
Sensor Circuit Malfunction
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input revolution (speed) of the transaxle. By comparing the input turbine speed
signal (NT) with the counter gear speed sensor signal (NC), the TCM detects the shift timing of the gears and appropriately controls the engine
torque and hydraulic pressure according to various conditions, thus, providing smooth gear shifts.
No comments:
Post a Comment