NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
2. CHECK FRONT PASSENGER AIRBAG ASSEMBLY (FRONT PASSENGER SIDE SQUIB 2ND STEP)
(a) Connect the instrument panel wire to the instrument panel wire assembly and center airbag sensor assembly.
(b) Connect SST (resistance 2.1 Ohms) to connector E (black connector).
CAUTION:
Never connect the tester to the front passenger airbag assembly (front passenger side squib 2nd step) for measurement, as this
may lead to a serious injury due to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1815, B1816, B1817, B1818 or 54 is not output.
Text in Illustration
HINT
Codes other than DTC B1815, B1816, B1817, B1818 and 54 may be output at this time, but they are not related to this check.
NG -- CHECK FRONT PASSENGER SIDE SQUIB 2ND STEP CIRCUIT
No comments:
Post a Comment