Friday, November 15, 2019

2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) P Code Charts Page 162


- Drive the vehicle for 2 to 3 minutes [E].



- Idle the engine for 5 minutes or more [F].



- Enter the following menus: Powertrain / Engine / Utility / All Readiness.



- Input the DTC: P0016 or P0018.



- Check the DTC judgment result [G].



- If the test result is UNKNOWN, enter the following menus: Powertrain / Engine / Trouble Codes / Pending.



- Read Pending DTCs [G].



HINT



If a pending DTC is output, the system is malfunctioning.



- If the test result is INCOMPLETE or UNKNOWN and no pending DTC is output, perform a universal trip and check for permanent DTCs



See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC



Check / Clear.



HINT



- If a permanent DTC is output, the system is malfunctioning.



- If no permanent DTC is output, the system is normal.



INSPECTION PROCEDURE



HINT



Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data



the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary,



if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.



PROCEDURE



1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0016 OR P0018)



(a) Connect the Techstream to the DLC3.



(b) Turn the engine switch on (IG).



(c) Turn the Techstream on.



(d) Enter the following menus: Powertrain / Engine / Trouble Codes.



(e) Read the DTCs.



Result:



HINT



If any DTCs other than P0016 or P0018 are output, troubleshoot those DTCs first.



B -- GO TO DTC CHART See: Diagnostic Trouble Code Descriptions/SFI System



A -- Continue to next step.



2. PERFORM ACTIVE TEST USING TECHSTREAM (CONTROL THE VVT SYSTEM (BANK 1 OR 2))



(a) Connect the Techstream to the DLC3.



(b) Start the engine.



(c) Turn the Techstream on.



(d) Warm up the engine.



(e) Enter the following menus: Powertrain / Engine / Active Test / Control the VVT system (Bank 1) or Control the VVT System (Bank

No comments:

Post a Comment