锟斤拷 If the indicator does not illuminate when tested or the incorrect indicator illuminates, replace the TCSCS.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Transfer Case Shift Control Switch Replacement (Without SLT) (See: Powertrain Management/Transmission Control Systems/Sensors and
Switches - Transmission and Drivetrain/Sensors and Switches - Transfer Case/Four Wheel Drive Selector Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for TCSCM replacement, setup, and programming
* Transfer Case High/Low Clutch Reset (See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Symptom Related Diagnostic
Procedures/MP 3023/3024-NQH - Transfer Case/Transfer Case High/Low Clutch Reset)
MP 3023/3024-NQH - Transfer Case
DTC B0775
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B0775 01
- 4WD HI Indicator Circuit Short to Battery
DTC B0775 06
- 4WD HI Indicator Circuit Short to Ground or Open
Diagnostic Fault Information
Circuit/System Description
The 4WD HI indicator circuit consists of a light emitting diode (LED) feed circuit, a LED and a LED control circuit. The indicator dimming control
circuit is the LED feed circuit and continuously supplies B+ to the 2WD HI, 4WD Auto, 4WD HI and 4WD LO LEDs. When the 4WD HI mode has
been selected by the driver, the transfer case shift control module (TCCM) provides a ground through the 4 HI indicator control circuit illuminating
the LED.
The TCCM tests the 4WD HI indicator circuit for unexpected voltage by monitoring the B+ supplied by the BCM on the indicator dimming control
circuit by grounding the 4WD HI indicator control circuit for 2 seconds during the Bulb Test at key ON.
Conditions for Running the DTC
B0775 01
* Ignition ON
* System voltage 10-18 V
* Instrument panel lights not dimmed.
* Daylight running lights MUST be commanded ON.
* Circuit tested when the 4WD HI indicator is commanded ON.
No comments:
Post a Comment