* Codes other than present DTC B1627, B1628, B1637, B1638, B1647, B1648, B1697, B1698 and 82 may be output at this time,
but they are not related to this check.
E -- CHECK PRESENT DTC
D -- CHECK CONNECTORS
C -- CHECK PAST DTC
B -- CHECK CONNECTORS
A -- Continue to next step.
2. CHECK PAST DTC
(a) Turn the engine switch on (IG), and wait for at least 60 seconds.
(b) Check for past DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
Result:
HINT
Codes other than past DTC B1627 and B1697 may be output at this time, but they are not related to this check.
C -- CHECK CONNECTORS
B -- CHECK SIDE AIRBAG SENSOR LH (FOR REAR SIDE)
A -- Continue to next step.
3. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the center airbag sensor assembly, side airbag sensor LH (for rear side), rear
airbag sensor LH and side airbag sensor LH (for front side). Also check that the connectors that link the No. 2 floor wire and front
door wire LH are properly connected.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the center airbag sensor assembly, side airbag sensor LH (for rear side), rear airbag sensor LH and
side airbag sensor LH (for front side). Also disconnect the connectors that link the No. 2 floor wire and front door wire LH.
(e) Check that the terminals of connectors are not damaged.
OK:
The terminals are not deformed or damaged.
NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
4. CHECK NO. 2 FLOOR WIRE (OPEN)
(a) Using SST, connect terminals 24 (BBL+) and 23 (BBL-) of connector B.
No comments:
Post a Comment