WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
* When the power management control ECU is replaced with a new one and the cable from the negative (-) battery terminal is
connected, the power source mode becomes the on (IG) mode. When the battery is removed and reinstalled, the power source
mode that was selected when the battery was removed is restored.
* Inspect the fuse for circuits related to this system before performing the following inspection procedure.
HINT
Check the connector connection to the terminal to make sure that there is no abnormality such as a loose connection, deformation,
etc.
PROCEDURE
1. CHECK HARNESS AND CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU) See: B2271
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) See: B2271
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY
GROUND)
OK -- Continue to next step.
3. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Remove the stop light switch assembly See: Lighting and Horns/Brake Light Switch/Service and Repair/Removal.
No comments:
Post a Comment