(b) Connect SST (resistance 2.1 Ohms) to connector C.
CAUTION:
Never connect the tester to the front passenger side knee airbag assembly (front passenger side knee airbag squib) for
measurement, as this may lead to a serious injury due to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1865, B1866, B1867, B1868, or 65 is not output.
Text in Illustration
HINT
Codes other than DTC B1865, B1866, B1867, B1868, and 65 may be output at this time, but they are not related to this check.
NG -- CHECK INSTRUMENT PANEL WIRE (FRONT PASSENGER SIDE KNEE AIRBAG SQUIB CIRCUIT)
OK -- REPLACE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY See: Restraints and Safety Systems/Air Bag
Systems/Air Bag/Service and Repair/Removal and Replacement/Knee Airbag Assembly (for Front Passenger Side)/Removal
3. CHECK INSTRUMENT PANEL WIRE (FRONT PASSENGER SIDE KNEE AIRBAG SQUIB CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
No comments:
Post a Comment