Systems/Camshaft Position Sensor/Service and Repair/Removal
OK -- Continue to next step.
4. CHECK EXHAUST CAMSHAFT
(a) Check the teeth of the signal plate.
OK:
Signal plate teeth do not have any cracks or deformation.
NG -- REPLACE EXHAUST CAMSHAFT See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push
Rods/Camshaft/Service and Repair/Removal
OK -- Continue to next step.
5. REPLACE VVT SENSOR FOR EXHAUST SIDE
(a) Replace the VVT sensor for exhaust side See: Powertrain Management/Computers and Control Systems/Camshaft Position
Sensor/Service and Repair/Removal.
NEXT -- Continue to next step.
6. CHECK WHETHER DTC OUTPUT RECURS (DTC P0365, P0367, P0368, P0390, P0392 AND/OR P0393)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTCs See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/DTC Check / Clear.
(e) Turn the engine switch off.
(f) Turn the engine switch on (IG) and turn the Techstream on.
(g) Start the engine and warm it up.
(h) Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
(i) Enter the following menus: Powertrain / Engine / Utility / All Readiness.
(j) Input the DTC: P0365, P0367, P0368, P0390, P0392, or P0393.
(k) Check the DTC judgment result.
Result:
HINT
If the engine does not start, replace the ECM.
B -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
A -- END
7. CHECK HARNESS AND CONNECTOR (VVT SENSOR FOR EXHAUST SIDE - ECM)
(a) Disconnect the VVT sensor connector.
No comments:
Post a Comment