(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
HINT
After replacing the center airbag sensor assembly, check for DTCs of the center airbag sensor assembly. If DTC B1650/32 is
detected, replace the occupant classification ECU See: Restraints and Safety Systems/Air Bag Systems/Seat Occupant
Sensor/Service and Repair/Occupant Classification ECU/Removal and perform "Zero Point Calibration" and "Sensitivity
Check" of the occupant classification system See: Restraints and Safety Systems/Testing and Inspection/Programming and
Relearning.
NG -- CHECK NO. 2 FLOOR WIRE (SHORT TO GROUND)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and
Safety Systems/Air Bag Control Module/Service and Repair/Removal
7. CHECK NO. 2 FLOOR WIRE (OPEN)
(a) Disconnect the front seat wire RH from the No. 2 floor wire.
HINT
SST has already been inserted into connector B.
(b) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment