Text in Illustration
(d) Reconnect the accelerator pedal sensor assembly connector.
NG -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
OK -- Continue to next step.
4. REPLACE ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Replace the accelerator pedal sensor assembly See: Powertrain Management/Fuel Delivery and Air Induction/Accelerator
Pedal/Service and Repair/Removal.
NEXT -- Continue to next step.
5. CHECK WHETHER DTC OUTPUT RECURS (ACCELERATOR PEDAL SENSOR ASSEMBLY DTCS)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTCs See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/DTC Check / Clear.
(e) Turn the engine switch off.
(f) Turn the engine switch on (IG) and turn the Techstream on.
(g) Start the engine and warm it up.
(h) Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
(i) Enter the following menus: Powertrain / Engine / Utility / All Readiness.
(j) Input the DTC: P2120, P2122, P2123, P2125, P2127, P2128 or P2138.
(k) Check the DTC judgment result.
Result:
B -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
A -- END
From 08/2009
2GR-FE ENGINE CONTROL: SFI SYSTEM: P2120,P2122,P2123,P2125,P2127,P2128,P2138: Throttle / Pedal Position Sensor / Switch
No comments:
Post a Comment