(a) Check if the navigation antenna cable is securely connected to the display and navigation module display.
OK:
Navigation antenna cable is securely connected.
NG -- SECURELY CONNECT NAVIGATION ANTENNA CABLE
OK -- Continue to next step.
2. REPLACE NAVIGATION ANTENNA ASSEMBLY
(a) Replace the navigation antenna assembly with a normal one and check if the same DTC is output again See: Accessories and
Optional Equipment/Antenna/Antenna, Navigation/Service and Repair/Removal.
(1) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY See: Accessories and Optional Equipment/Navigation
System/Service and Repair/Navigation Receiver (for HDD)/Removal
OK -- END
Safety Connect System
CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: B15C0,B15C1: Short in GPS Antenna
B15C0 - Short in GPS Antenna
B15C1 - Open in GPS Antenna
DESCRIPTION
This DTC is set when the DCM (Telematics Transceiver) detects an open or a short in the telephone and GPS antenna circuit. The DCM (Telematics
Transceiver) receives 1574.42 - 1576.42 MHz radio frequency signal from satellites through the telephone and GPS antenna assembly. The cable is
a 50 Ohms coaxial cable.
HINT
Refer to "PARTS LOCATION" for the installation location of telephone and GPS antenna cord See: Accessories and Optional
Equipment/Emergency Contact Module/Locations/Safety Connect System.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Perform "HEALTH CHECK" and check for current DTCs See: Accessories and Optional Equipment/Emergency Contact
No comments:
Post a Comment