- Following the Control the Injection Volume for A/F Sensor procedure enables technicians to check and graph the voltage outputs of both
the air fuel ratio and heated oxygen sensors.
- To display the graph, enter the following menus: Powertrain / Engine / Active Test / Control the Injection Volume for A/F Sensor / A/F
Control System / AFS Voltage B1S1 and O2S B1S2 or AFS Voltage B2S1 and O2S B2S2.
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
HINT
- Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame
data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or
stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the
malfunction occurred.
- If the OX1B wire from the ECM connector is short-circuited to the +B wire, DTC P0136 will be set.
- If the OX2B wire from the ECM connector is short-circuited to the +B wire, DTC P0156 will be set.
PROCEDURE
1. READ DTC OUTPUT (DTC P0136, P0137, P0138, P0139, P0156, P0157, P0158 OR P0159)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Engine / Trouble Codes.
No comments:
Post a Comment