INSPECTION PROCEDURE
NOTICE:
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.
* After replacing the radio receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the
XM radio ID is necessary. (w/ SDARS System)
PROCEDURE
1. CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
(a) Check for optional components.
(1) Check that optional components (including associated wiring) which generate radio waves are not installed.
Result:
HINT
* Electrical noise from radio waves generated by optional components or the wiring for those components may affect MOST
communication.
* This DTC may be stored when an MOST communication error occurs due to electrical noise.
B -- CHECK DTC
A -- Continue to next step.
2. REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING)
(a) Remove optional components (including associated wiring).
NOTICE:
Do not remove optional components or associated wiring without the permission of the customer.
NEXT -- Continue to next step.
3. CHECK DTC
(a) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for HDD).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)
OK -- END
1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)
No comments:
Post a Comment