2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) P Code Charts Page 426

- If a permanent DTC is output, the system is malfunctioning.

- If no permanent DTC is output, the system is normal.

INSPECTION PROCEDURE

PROCEDURE

1. READ OUTPUT DTC (DTC P060A)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Clear the DTCs See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear.

(e) Turn the engine switch off.

(f) Turn the Techstream off.

(g) Disconnect the Techstream.

(h) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

(i) Connect the cable to the negative (-) battery terminal.

(j) Connect the Techstream to the DLC3.

(k) Turn the engine switch on (IG).

(l) Turn the Techstream on.

(m)Enter the following menus: Powertrain / Engine / Trouble Codes.

(n) Read the DTCs.

Result:

B -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and

Repair/Removal

A -- CHECK FOR INTERMITTENT PROBLEMS

Up to 08/2009

2GR-FE ENGINE CONTROL: SFI SYSTEM: P060B: Internal Control Module A/D Processing Performance

P060B - Internal Control Module A/D Processing Performance

DESCRIPTION

This DTC is output when a communication error occurs in the ECM.