HINT
Refer to "PARTS LOCATION" for the installation location of telephone and GPS antenna cord See: Accessories and Optional
Equipment/Emergency Contact Module/Locations/Safety Connect System.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Perform "HEALTH CHECK" and check for current DTCs See: Accessories and Optional Equipment/Emergency Contact
Module/Testing and Inspection/Initial Inspection and Diagnostic Overview/Safety Connect System/Health Check.
Result:
B -- CHECK FOR INTERMITTENT PROBLEMS See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting
A -- Continue to next step.
2. INSPECT TELEPHONE AND GPS ANTENNA ASSEMBLY
(a) Disconnect the telephone and GPS antenna assembly connector from the telephone and GPS antenna cord (No. 4 antenna cord
sub-assembly).
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY See: Accessories and Optional
Equipment/Antenna/Antenna, Phone/Service and Repair/Telephone and GPS Antenna/Removal
OK -- Continue to next step.
No comments:
Post a Comment