INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC OUTPUT
(a) Using the Techstream, enter the following menus: Body Electrical / Pre-Collision / Trouble Codes.
(b) Clear the DTCs See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Pre-Collision System.
(c) Turn the engine switch off.
(d) Turn the engine switch on (IG).
(e) Recheck for DTCs.
OK:
DTCs are not output.
NG -- REPLACE SEAT BELT CONTROL ECU
OK -- CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed
With Troubleshooting
From 08/2009
PRE-COLLISION: PRE-COLLISION SYSTEM:
B2015,B2016,B2020,B2021,B2025-B2027,B2030-B2032,B2035,B2040,B2041,B2043,B2047: Open in Right Side Upper MOS
B2015 - Open in Right Side Upper MOS
B2016 - Open in Right Side Lower MOS
B2020 - Open in Left Side Upper MOS
No comments:
Post a Comment