These DTCs are recorded when a malfunction is detected in the front passenger side knee airbag squib circuit.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
* Perform the simulation method by selecting Check Mode (Signal Check) using the Techstream See: Restraints and Safety
Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Check Mode Procedure.
* After selecting Check Mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system
or driving the vehicle on a city or rough road See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting.
PROCEDURE
1. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the front passenger side knee airbag assembly and center airbag sensor assembly.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
No comments:
Post a Comment