NG -- REPLACE TELEPHONE AND GPS ANTENNA CORD (NO. 5 ANTENNA CORD SUB-ASSEMBLY) See:
Accessories and Optional Equipment/Antenna/Antenna, Phone/Service and Repair/Telephone and GPS Antenna Cords/Removal
OK -- Continue to next step.
5. INSPECT TELEPHONE AND GPS ANTENNA CORDS (NO. 2 INSTRUMENT PANEL WIRE)
(a) Disconnect the No. 2 instrument panel wire (antenna cord sub-assembly) connector from the DCM (Telematics Transceiver).
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE NO. 2 INSTRUMENT PANEL WIRE (ANTENNA CORD SUB-ASSEMBLY)
OK -- Continue to next step.
6. REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY
(a) Replace the telephone and GPS antenna assembly with a normal one and check if the same problem occurs again See: Accessories
and Optional Equipment/Antenna/Antenna, Phone/Service and Repair/Telephone and GPS Antenna/Removal.
OK:
The system returns to normal.
NG -- REPLACE DCM (TELEMATICS TRANSCEIVER)
OK -- END
7. REPLACE DCM (TELEMATICS TRANSCEIVER)
(a) Replace the DCM (Telematics Transceiver) See: Accessories and Optional Equipment/Emergency Contact Module/Service and
Repair/Removal.
NOTICE:
* The engine switch must be off.
* Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT -- PERFORM DCM ACTIVATION See: Accessories and Optional Equipment/Emergency Contact Module/Testing and
Inspection/Scan Tool Testing and Procedures/DCM Activation
No comments:
Post a Comment