WIRING DIAGRAM
INSPECTION PROCEDURE
HINT
* Perform the simulation method by selecting Check Mode (Signal Check) using the Techstream See: Restraints and Safety
Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Check Mode Procedure.
* After selecting Check Mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system
or driving the vehicle on a city or rough road See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting.
PROCEDURE
1. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the front seat outer belt assembly LH and center airbag sensor assembly.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the front seat outer belt assembly LH and center airbag sensor assembly.
(e) Check that the terminals of the connectors are not damaged.
No comments:
Post a Comment