NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
2. CHECK STEERING PAD (DRIVER SIDE SQUIB 2ND STEP)
(a) Connect the instrument panel wire to the center airbag sensor assembly and spiral cable.
(b) Connect SST (resistance 2.1 Ohms) to connector E (black connector).
CAUTION:
Never connect the tester to the steering pad (driver side squib 2nd step) for measurement, as this may lead to a serious injury due
to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1810, B1811, B1812, B1813 or 53 is not output.
Text in Illustration
HINT
Codes other than DTC B1810, B1811, B1812, B1813 and 53 may be output at this time, but they are not related to this check.
NG -- CHECK DRIVER SIDE SQUIB 2ND STEP CIRCUIT
No comments:
Post a Comment