(b) Connect SST (resistance 2.1 Ohms) to connector C.
CAUTION:
Never connect the tester to the curtain shield airbag assembly RH (curtain shield squib RH) for measurement, as this may lead to
a serious injury due to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1830, B1831, B1832, B1833 or 57 is not output.
Text in Illustration
HINT
Codes other than DTC B1830, B1831, B1832, B1833 and 57 may be output at this time, but they are not related to this check.
NG -- CHECK FLOOR WIRE (CURTAIN SHIELD SQUIB RH CIRCUIT)
OK -- REPLACE CURTAIN SHIELD AIRBAG ASSEMBLY RH See: Restraints and Safety Systems/Air Bag Systems/Air
Bag/Service and Repair/Removal and Replacement/Curtain Shield Airbag Assembly/Removal
1. CHECK FLOOR WIRE (CURTAIN SHIELD SQUIB RH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
No comments:
Post a Comment