INSPECTION PROCEDURE
HINT
* Perform the simulation method by selecting the check mode (Signal Check) using the Techstream See: Restraints and Safety
Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Check Mode Procedure.
* After selecting the check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag
system or driving the vehicle on a city or rough road See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Diagrams/Diagnostic Aids/How To Troubleshoot ECU Controlled Systems/How To Proceed With Troubleshooting.
PROCEDURE
1. CHECK CONNECTORS
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the steering pad, spiral cable and center airbag sensor assembly.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the steering pad, spiral cable and center airbag sensor assembly.
(e) Check that the terminals of the connectors are not damaged.
OK:
The terminals are not deformed or damaged.
(f) Check that the spiral cable connector (on the steering pad side) is not damaged.
OK:
The lock button is not disengaged, or the claw of the lock is not deformed or damaged.
(g) Check that the short springs for the instrument panel wire and spiral cable with the activation prevention mechanism are not deformed
or damaged.
OK:
The short springs are not deformed or damaged.
No comments:
Post a Comment