PROCEDURE
1. CHECK HARNESS AND CONNECTOR (BATTERY - PARK/NEUTRAL POSITION SWITCH)
(a) Disconnect the park/neutral position switch connector.
(b) Turn the engine switch on (IG).
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (OUTPUT SIGNAL)
(a) Turn the engine switch on (IG).
(b) Measure the voltage according to the value(s) in the table below.
No comments:
Post a Comment