TYPICAL ENABLING CONDITIONS
The stop light switch remains ON during GO and STOP 5 times.
GO and STOP are defined as follows;
TYPICAL MALFUNCTION THRESHOLDS
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Perform the universal trip to clear permanent DTCs See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/U660F Automatic Transaxle
System/DTC Check / Clear.
PROCEDURE
1. READ VALUE USING DATA LIST (STP SIGNAL)
HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read
without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be
discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save
diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference
values when deciding whether a part is faulty or not.
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
No comments:
Post a Comment