OK:
Connectors are properly connected.
NG -- CONNECT CONNECTORS PROPERLY
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - OUTSIDE ELECTRICAL KEY OSCILLATOR)
(a) Disconnect the certification ECU (smart key ECU assembly) connector.
(b) Disconnect the outside electrical key oscillator (for rear side) connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT OUTSIDE ELECTRICAL KEY OSCILLATOR
(a) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment