Standard Resistance:
Text in Illustration
HINT
After replacing the center airbag sensor assembly, check for DTCs of the center airbag sensor assembly. If DTC B1650/32 is
detected, replace the occupant classification ECU See: Restraints and Safety Systems/Air Bag Systems/Seat Occupant
Sensor/Service and Repair/Occupant Classification ECU/Removal and perform "Zero Point Calibration" and "Sensitivity
Check" of the occupant classification system See: Restraints and Safety Systems/Testing and Inspection/Programming and
Relearning.
NG -- CHECK NO. 2 FLOOR WIRE (SHORT TO GROUND)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraints and
Safety Systems/Air Bag Control Module/Service and Repair/Removal
7. CHECK NO. 2 FLOOR WIRE (OPEN)
(a) Disconnect the front seat wire RH from the No. 2 floor wire.
HINT
SST has already been inserted into connector B.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPLACE NO. 2 FLOOR WIRE
OK -- REPLACE FRONT SEAT WIRE RH
8. CHECK NO. 2 FLOOR WIRE (SHORT)
(a) Disconnect the front seat wire RH from the No. 2 floor wire.
No comments:
Post a Comment