1. PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.
ABS/VSC/TRAC
(e) Select "Buzzer", and perform the Active Test.
OK:
Skid control buzzer sounds.
NG -- GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Testing and Inspection/Component Tests and General Diagnostics/Skid Control Buzzer Circuit
OK -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Components
Up to 08/2009
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P1578: Brake System Malfunction
P1578 - Brake System Malfunction
DESCRIPTION
This DTC is output when the VSC system has a problem. Check the VSC system when this DTC is output.
HINT
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs
in the CAN communication system are output.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
No comments:
Post a Comment