Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - SKID CONTROL
ECU)
OK -- Continue to next step.
7. CHECK DTC OUTPUT
(a) Clear the DTCs See: Cruise Control/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Dynamic Radar Cruise
Control System.
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed of 50 km/h (31 mph) or more.
(2) Turn the cruise control main switch on.
(3) Push the -SET switch to activate the cruise control.
(c) Check for DTCs See: Cruise Control/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Dynamic Radar Cruise
Control System.
Result:
B -- REPLACE BRAKE ACTUATOR See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic
Control Assembly - Antilock Brakes/Service and Repair/Components
A -- END
8. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - POWER SOURCE CIRCUIT)
(a) Disconnect the stop light switch assembly connector.
Text in Illustration
(b) Measure the voltage according to the value(s) in the table below.
No comments:
Post a Comment