Standard Voltage:
(d) Reconnect the ECM connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECM)
OK -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Components
Dynamic Radar Cruise Control System
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: P0575: Cruise Control Input Circuit
P0575 - Cruise Control Input Circuit
DESCRIPTION
This DTC indicates a malfunction in the ECM.
HINT
The ECM receives signals from each sensor to control all the functions of the cruise control with the microcomputer. When a
malfunction is detected, fail-safe remains on until the engine switch is turned off.
INSPECTION PROCEDURE
PROCEDURE
1. CHECK DTC
(a) Clear the DTCs See: Cruise Control/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Dynamic Radar Cruise
Control System.
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed of 50 km/h (31 mph) or more.
(2) Turn the cruise control main switch on.
(3) Push the -SET switch to activate the cruise control.
(c) Check for DTCs See: Cruise Control/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Dynamic Radar Cruise
Control System.
Result:
B -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
No comments:
Post a Comment