(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY (A/C CONTROL PANEL) POWER
SOURCE)
OK -- END
4. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY (A/C CONTROL PANEL) POWER SOURCE)
(a) Disconnect the radio receiver assembly (A/C control panel) connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (AVC-LAN COMMUNICATION LINE)
(a) Disconnect the multi-display assembly connector.
(b) Disconnect the radio receiver assembly (A/C control panel) connector.
No comments:
Post a Comment