(1) Drive the vehicle at a speed of 50 km/h (31 mph) or more.
(2) Turn the cruise control main switch on.
(3) Push the -SET switch to activate the cruise control.
(c) Check for DTCs See: Cruise Control/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Dynamic Radar Cruise
Control System.
Result:
B -- REPLACE BRAKE ACTUATOR See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic
Control Assembly - Antilock Brakes/Service and Repair/Components
A -- END
8. CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - POWER SOURCE CIRCUIT)
(a) Disconnect the stop light switch assembly connector.
Text in Illustration
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(c) Reconnect the stop light switch assembly connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECU IG2 FUSE,
STOP FUSE)
OK -- Continue to next step.
9. INSPECT STOP LIGHT SWITCH ASSEMBLY
(a) Remove the stop light switch assembly See: Lighting and Horns/Brake Light Switch/Service and Repair/Removal.
No comments:
Post a Comment