(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Check that the connectors are properly connected to the center airbag sensor assembly and front airbag sensor RH. Also check that the
connectors that link the engine room main wire and instrument panel wire are properly connected.
OK:
The connectors are properly connected.
HINT
If the connectors are not connected securely, reconnect the connectors and proceed to the next inspection.
(d) Disconnect the connectors from the center airbag sensor assembly and front airbag sensor RH. Also disconnect the connectors that link
the engine room main wire and instrument panel wire.
(e) Check that the connector terminals are not damaged.
OK:
The terminals are not deformed or damaged.
NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
2. CHECK FRONT AIRBAG SENSOR RH CIRCUIT (OPEN)
(a) Connect the connectors that link the engine room main wire and instrument panel wire.
(b) Using SST, connect terminals 29 (+SR) and 27 (-SR) of connector B.
NOTICE:
Do not forcibly insert SST into the terminals of the connector when connecting.
SST : 09843-18040
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- CHECK INSTRUMENT PANEL WIRE (OPEN)
OK -- Continue to next step.
3. CHECK FRONT AIRBAG SENSOR RH CIRCUIT (SHORT)
(a) Disconnect SST from connector B.
No comments:
Post a Comment