Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR
(a) Disconnect the G16 multi-display controller sub-assembly connector.
(b) Disconnect the G6 display and navigation module display connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
4. REPLACE MULTI-DISPLAY CONTROLLER SUB-ASSEMBLY
No comments:
Post a Comment