down. The tilt position sensor (Hall IC) in the tilt motor detects the tilt angle of the steering column and outputs a signal to the multiplex tilt and
telescopic ECU based on that angle.
HINT
Limit positions can be confirmed on the Techstream.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
1. PERFORM ACTIVE TEST USING TECHSTREAM (TILT OPERATION)
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG).
(d) Turn the Techstream on.
(e) Check that the steering wheel tilts up and down. Enter the following menus: Body Electrical / Tilt & Telescopic / Active Test.
No comments:
Post a Comment