Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(b) Disconnect the front seat outer belt assembly RH connector.
(c) Disconnect the seat belt control ECU connector.
(d) Using a service wire, connect MOR+ and MOR- of the connector on the front seat outer belt assembly RH.
NOTICE:
Do not forcibly insert the service wire into the terminals of the connector.
(e) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Text in Illustration
(f) Reconnect the seat belt control ECU and front seat outer belt assembly RH connectors.
(g) Connect the cable to the negative (-) battery terminal.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT
BELT CONTROL ECU)
OK -- REPLACE SEAT BELT CONTROL ECU
Up to 08/2009
PRE-COLLISION: PRE-COLLISION SYSTEM: B2005: Short to B+ in Seat Belt Motor LH Circuit
B2005 - Short to B+ in Seat Belt Motor LH Circuit
DESCRIPTION
The seat belt control ECU receives information from the driving support ECU using CAN communication and tightens the seat belt by operating the
motor in the front seat outer belt assembly LH.
No comments:
Post a Comment