1. READ OUTPUT DTC (DTC P060E)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Clear the DTCs See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/DTC Check / Clear.
(e) Turn the engine switch off.
(f) Turn the Techstream off.
(g) Disconnect the Techstream.
(h) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(i) Connect the cable to the negative (-) battery terminal.
(j) Connect the Techstream to the DLC3.
(k) Turn the engine switch on (IG).
(l) Turn the Techstream on.
(m)Enter the following menus: Powertrain / Engine / Trouble Codes.
(n) Read the DTCs.
Result:
B -- REPLACE ECM See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal
A -- CHECK FOR INTERMITTENT PROBLEMS
Up to 08/2009
2GR-FE ENGINE CONTROL: SFI SYSTEM: P062F: Internal Control Module EEPROM Error
P062F - Internal Control Module EEPROM Error
DESCRIPTION
The ECM monitors its internal operation and it stores this DTC when it detects an internal malfunction.
MONITOR DESCRIPTION
The ECM monitors its internal operation. If the internal operation is malfunctioning, the ECM illuminates the MIL and stores a DTC.
No comments:
Post a Comment