(b) Disconnect the TCM connector.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- CHECK HARNESS AND CONNECTOR (TCM - PARK/NEUTRAL POSITION SWITCH)
OK -- REPLACE TCM See: Powertrain Management/Transmission Control Systems/Relays and Modules - Transmission and
Drivetrain/Relays and Modules - A/T/Control Module/Service and Repair/U660F Automatic Transaxle/Removal
1. CHECK HARNESS AND CONNECTOR (TCM - PARK/NEUTRAL POSITION SWITCH)
(a) Disconnect the TCM connector.
(b) Remove the ST relay from the engine room relay block.
(c) Disconnect the park/neutral position switch connector.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- CHECK STARTER SIGNAL CIRCUIT
Up to 08/2009
2GR-FE ENGINE CONTROL: SFI SYSTEM: P0630: VIN not Programmed or Mismatch - ECM / PCM
No comments:
Post a Comment