(d) Measure the resistance between the display and navigation module display and remote touch according to the value(s) in the table
below.
Standard Resistance:
(e) Measure the resistance between the remote touch and radio receiver assembly according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. REPLACE REMOTE TOUCH (REMOTE OPERATION BOARD)
(a) Replace the remote touch See: Accessories and Optional Equipment/Navigation System/Navigation Display/Service and
Repair/Overhaul/Disassembly.
(b) Clear the DTCs See: Accessories and Optional Equipment/Navigation System/Testing and Inspection/Reading and Clearing
Diagnostic Trouble Codes/Navigation System (for DVD).
(c) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
NG -- REPLACE DISPLAY AND NAVIGATION MODULE DISPLAY See: Accessories and Optional Equipment/Navigation
System/Service and Repair/Navigation Receiver (for DVD)/Removal
No comments:
Post a Comment