NG -- REPLACE WIRE HARNESS
OK -- Continue to next step.
2. CHECK STEERING PAD (DRIVER SIDE SQUIB)
(a) Connect the instrument panel wire to the center airbag sensor assembly and spiral cable.
(b) Connect SST (resistance 2.1 Ohms) to connector E.
CAUTION:
Never connect the tester to the steering pad (driver side squib) for measurement, as this may lead to a serious injury due to airbag
deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1800, B1801, B1802, B1803 or 51 is not output.
Text in Illustration
HINT
Codes other than DTC B1800, B1801, B1802, B1803 and 51 may be output at this time, but they are not related to this check.
NG -- CHECK DRIVER SIDE SQUIB CIRCUIT
No comments:
Post a Comment