(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Power Source Control / Data List.
(e) Read the Data List according to the value(s) in the Techstream.
Power Source Control
OK:
Stop (engine is stopped) and Run (steering lock is locked) appear on the screen.
NG -- GO TO SFI SYSTEM
OK -- Continue to next step.
5. CHECK POWER MANAGEMENT CONTROL ECU
(a) Reconnect the F7 connector to the power management control ECU.
(b) Reconnect the A43 connector to the ECM.
(c) Connect an F7-4 (NE) and body ground.
(d) Check for pulses according to the condition(s) in the table below.
OK:
Text in Illustration
NG -- GO TO SFI SYSTEM
OK -- REPLACE POWER MANAGEMENT CONTROL ECU See: Power and Ground Distribution/Power Distribution
Module/Service and Repair/Removal
Up to 08/2009
NETWORKING: LIN COMMUNICATION SYSTEM: B2287: LIN Communication Master Malfunction
B2287 - LIN Communication Master Malfunction
No comments:
Post a Comment