(b) Connect SST (resistance 2.1 Ohms) to connector C.
CAUTION:
Never connect the tester to the front seat side airbag assembly RH (side squib RH) for measurement, as this may lead to a serious
injury due to airbag deployment.
NOTICE:
* Do not forcibly insert SST into the terminals of the connector when connecting.
* Insert SST straight into the terminals of the connector.
SST : 09843-18061
(c) Connect the cable to the negative (-) battery terminal.
(d) Turn the engine switch on (IG), and wait for at least 60 seconds.
(e) Clear the DTCs stored in the memory See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and
Clearing Diagnostic Trouble Codes/DTC Check / Clear.
(f) Turn the engine switch off.
(g) Turn the engine switch on (IG), and wait for at least 60 seconds.
(h) Check for DTCs See: Restraints and Safety Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic
Trouble Codes/DTC Check / Clear.
OK:
DTC B1820, B1821, B1822, B1823 or 55 is not output.
HINT
Codes other than DTC B1820, B1821, B1822, B1823 and 55 may be output at this time, but they are not related to this check.
Text in Illustration
NG -- CHECK FLOOR WIRE (SIDE SQUIB RH CIRCUIT)
OK -- REPLACE FRONT SEAT ASSEMBLY RH See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Front Seat Assembly/Removal
1. CHECK FLOOR WIRE (SIDE SQUIB RH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
No comments:
Post a Comment