2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) P Code Charts Page 2236

OK -- REPLACE TRANSMISSION WIRE See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Wiring

Harness/Service and Repair/U660E Automatic Transaxle/Removal

4. CHECK TRANSMISSION WIRE

(a) Remove the oil strainer assembly.

(b) Remove the TCM.

(c) Disconnect the connector from the ATF temperature sensor assembly.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Text in Illustration

NG -- REPLACE TRANSMISSION WIRE See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Wiring

Harness/Service and Repair/U660E Automatic Transaxle/Removal

OK -- Continue to next step.

1. REPLACE ATF TEMPERATURE SENSOR ASSEMBLY

(a) See: Powertrain Management/Transmission Control Systems/Sensors and Switches - Transmission and Drivetrain/Sensors and

Switches - A/T/Transmission Temperature Sensor/Switch/Service and Repair/U660E Automatic Transaxle/Removal.

NEXT -- Continue to next step.

1. CHECK IF DTC OUTPUT RECURS

(a) Connect the Techstream to the DLC3.

(b) Start the engine and turn the Techstream on.

(c) Enter the following menus: / ECT / DTC / Clear.

HINT

Write down the currently output DTCs before clearing them.

(d) Perform the monitor drive pattern See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and

Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/U660E Automatic Transaxle System.

(e) Enter the following menus: / ECT / DTC.

(f) Read the DTCs using the Techstream.