2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) P Code Charts Page 62

(b) Remove the oil control valve filter RH or oil control valve filter LH.

(c) Check that the oil control valve filter and oil pipe are not clogged.

OK:

The oil control valve filter and oil pipe are not clogged.

(d) Reinstall the oil control valve filter RH or oil control valve filter LH.

(e) Reinstall the No. 1 oil pipe or No. 2 oil pipe.

NG -- REPLACE OIL CONTROL VALVE FILTER OR OIL PIPE See: Engine, Cooling and Exhaust/Engine/Service and

Repair/Overhaul/Disassembly

OK -- Continue to next step.

4. REPLACE CAMSHAFT TIMING GEAR ASSEMBLY

(a) Replace the camshaft timing gear assembly (bank 1 or bank 2) See: Engine, Cooling and Exhaust/Engine/Camshaft, Lifters and Push

Rods/Camshaft/Service and Repair/Removal.

NEXT -- Continue to next step.

1. CHECK WHETHER DTC OUTPUT RECURS

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Clear the DTCs See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing

Diagnostic Trouble Codes/DTC Check / Clear.

(e) Turn the engine switch off.

(f) Turn the engine switch on (IG) and turn the Techstream on.

(g) Start the engine and warm it up.

(h) Drive the vehicle in accordance with the driving pattern described in the CONFIRMATION DRIVING PATTERN.

(i) Enter the following menus: Powertrain / Engine / Utility / All Readiness.

(j) Input the DTC: P0011, P0012, P0021 or P0022.

(k) Check the DTC judgment result.

Result:

HINT

DTC P0011, P0012, P0021 or P0022 is output when foreign objects in engine oil are caught in some parts of the system. These

codes will remain stored even if the system returns to normal after a short time. These foreign objects may then be captured by