(d) Reconnect the front seat outer belt assembly RH connector.
NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH See: Restraints and Safety Systems/Seat Belt Systems/Seat
Belt/Service and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Removal
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT BELT CONTROL ECU)
(a) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(b) Disconnect the front seat outer belt assembly RH connector.
(c) Disconnect the seat belt control ECU connector.
(d) Connect the cable to the negative (-) battery terminal.
(e) Turn the engine switch on (IG).
(f) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
(g) Disconnect the cable from the negative (-) battery terminal.
(h) Reconnect the seat belt control ECU and front seat outer belt assembly RH connectors.
(i) Connect the cable to the negative (-) battery terminal.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT SEAT OUTER BELT ASSEMBLY RH - SEAT
BELT CONTROL ECU)
OK -- REPLACE SEAT BELT CONTROL ECU
Up to 08/2009
PRE-COLLISION: PRE-COLLISION SYSTEM: B2001: Short to GND in Seat Belt Motor RH Circuit
B2001 - Short to GND in Seat Belt Motor RH Circuit
DESCRIPTION
The seat belt control ECU receives information from the driving support ECU using CAN communication and tightens the seat belt by operating the
No comments:
Post a Comment