2010 Lexus Truck RX 350 AWD V6-3.5L (2GR-FE) P Code Charts Page 1145

Result:

B -- READ VALUE USING TECHSTREAM (CYLINDER #1 (TO #6) MISFIRE COUNT)

A -- Continue to next step.

5. PERFORM ACTIVE TEST USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine / Active Test / Prohibit the Catalyst OT Misfire prevent F/C.

(e) Perform the Active Test.

NOTICE:

When performing the Active Test, make sure that the vehicle is stopped and either idling or being revved within 3000 rpm.

NEXT -- Continue to next step.

6. READ VALUE USING TECHSTREAM (CYLINDER #1 (TO #6) MISFIRE COUNT)

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on (Step "A").

(d) Enter the following menus: Powertrain / Engine / Data List / Cylinder #1 (to #6) Misfire Count (Step "B").

(e) Read each value for Cylinder #1 (to #6) Misfire Count displayed on the Techstream. If no misfire counts occur in any cylinders,

perform the following procedure:

(1) Start the engine and let it idle.

(2) Move the shift lever to D.

(3) Check the Cylinder #1 (to #6) Misfire Count.

(4) If misfire counts are still not displayed, perform steps ("A") and ("B").

(f) Drive the vehicle while satisfying the Misfire RPM and Misfire Load values noted in the "Read Value Using Techstream (Misfire

RPM and Misfire Load)" procedure above.

(g) Read Cylinder #1 (to #6) Misfire Count or the DTCs displayed on the Techstream.

Result:

HINT

- If it is difficult to reproduce misfires for each cylinder, check the Data List item called Misfire Margin. Try to find vehicle

driving conditions that lower the Misfire Margin value. Values above 30% are considered normal.

- If the Coolant Temp value of the freeze frame data is below 75锟斤拷C (167锟斤拷F), the misfire may be detected only when the engine is

cold.

- If Engine Run Time value of the freeze frame data is below 120 seconds, the misfire may be detected immediately after the

engine is started.

B -- CHECK INTAKE SYSTEM

A -- Continue to next step.