- Idle the engine for 1 minute or more [B].
- Enter the following menus: Powertrain / Engine / Utility / All Readiness.
- Input the DTC: P050B.
- Check the DTC judgment result [C].
HINT
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE or UNKNOWN, idle the engine for 3 minutes, let the engine cool down, and then
perform steps [A] through [C].
- If the test result is UNKNOWN, enter the following menus: Powertrain / Engine / Trouble Codes / Pending.
- Read Pending DTCs.
HINT
If a pending DTC is output, the system is malfunctioning.
- If the test result is INCOMPLETE or UNKNOWN and no pending DTC is output, perform a universal trip and check for permanent DTCs
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC
Check / Clear.
HINT
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.
INSPECTION PROCEDURE
HINT
- DTC P050B may be set when the engine shows the symptom as listed below. If necessary, check the trouble area as listed
below.
- Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame
data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or
stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the
malfunction occurred.
PROCEDURE
1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P050B)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following the menus: Powertrain / Engine / Trouble Codes.
No comments:
Post a Comment