HINT
Codes other than DTC B1855, B1856, B1857, B1858 and 63 may be output at this time, but they are not related to this check.
NG -- CHECK NO. 2 FLOOR WIRE (REAR SIDE SQUIB LH CIRCUIT)
OK -- REPLACE REAR SEAT ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seat Assembly (for LH Side)/Removal
3. CHECK NO. 2 FLOOR WIRE (REAR SIDE SQUIB LH CIRCUIT)
(a) Turn the engine switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect SST from connector C.
(d) Disconnect the No. 2 floor wire from the center airbag sensor assembly.
(e) Check the short to B+ in the circuit.
(1) Connect the cable to the negative (-) battery terminal.
(2) Turn the engine switch on (IG).
(3) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
(f) Check the open in the circuit.
(1) Turn the engine switch off.
(2) Disconnect the cable from the negative (-) battery terminal.
NOTICE:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(3) Measure the resistance according to the value(s) in the table below.
No comments:
Post a Comment